skinnyvilla.blogg.se - Electroacoustics toolbox

#ELECTROACOUSTICS TOOLBOX SOFTWARE#
#ELECTROACOUSTICS TOOLBOX PROFESSIONAL#
#ELECTROACOUSTICS TOOLBOX SERIES#

Off Topic: Most electronic musicians are familiar with the idea of acoustic treatment, and using it to capture clean recordings or to improve the accuracy of audio playback.įew, though, have experience with acoustic treatment taken to its extreme, as it is in an anechoic chamber.Īnechoic chambers are rooms designed to block outside sounds and completely absorb sounds generated inside. Noise: 20dB SPL equivalent (A weighted).Min Output Load: 600Ω between pins 2 & 3.Output Impedance: 65Ω balanced (between pins 2 & 3).Power Requirements: 24 – 48V Phantom, 10mA.Frequency Response: 3Hz to 50kHz ☑/-3dB.Re-calibration recommended every five (5) years.Storage Temp Range: -40 deg C to +80 deg C ( -40 deg.Operating Temp Range: -20 deg C to +60 deg C ( -4 deg.

#ELECTROACOUSTICS TOOLBOX SERIES#

Each M Series microphone is delivered with its own calibration chart providing its individually measured open-circuit sensitivity and the frequency response curve.

Meets or exceeds ANSI Type 1 and applicable IEC 61094 requirements.

Used by SMAART™, MLSSA™, Spectrafoo™, TEF™ and RTA in addition to acoustic measurement systems manufactured by dbx, DEQX and others.

Flat frequency response, fast impulse response and exceptional polar characteristics.

Our top of the line measurement microphone with extraordinary impulse response for those who have stringent requirements and demand the very best.

Ideally suited for acoustical measurements that require extended frequency response, including high-end loudspeaker design and quality control, scientific research, measurements of ultrasonic or subsonic transducers, or any application where an extremely accurate free-field measurement microphone is required.

An Electronic Calibration File (ECF) is generated for each microphone during final testing, and can be downloaded free of charge after product registration.

#ELECTROACOUSTICS TOOLBOX SOFTWARE#

Lightning fast impulse response and linear phase response make the M50 ideal for use with high-quality FFT-based real-time audio system measurement software like SMAART™, SIM™, REW™, Electroacoustics Toolbox™, FuzzMeasure™ and others, as well as for use in PA system alignment and loudspeaker design.Įvery M50 is individually hand-tuned and tested and is delivered with its own printed frequency response chart. With temperature compensated electronics, the M50 was built to deliver repeatable results no matter what the environment. The M50 has a 140dB SPL rating without distortion and no handling noise. Its omnidirectional polar response exceptionally consistent, providing an even coherent response a the direct and off-axis sections of the microphone capsule. It has an ultra wide flat frequency response that extends from 3Hz to 50kHz and is flat throughout the entire spectrum. The M50’s audio performance is unparalleled. Known for its accuracy, reliability and consistency, the M50 is the top of the line measurement microphone with extraordinary impulse response for those who have stringent requirements and demand the very best. The ultra wide frequency response of 3Hz to 50kHz is flat throughout the entire spectrum and results in accurate room calibration using Smaart, MLSSA, SIMM and TEF based systems.

#ELECTROACOUSTICS TOOLBOX PROFESSIONAL#

The M50 is a professional measurement microphone intended for large room calibration.